steakpediaThe reference on steak

Home›Cooking›Denver steak

Main course · Chuck steak, grilled or seared

Denver steak

A Denver steak is cut from the serratus ventralis, the marbled muscle under the shoulder blade in the chuck (IMPS 116G). It is usually sold 2–2.5 cm / ¾–1 in thick (170–280 g / 6–10 oz), and it is a steak for direct, high heat: 6–10 minutes in total over a hot grill or 6–8 minutes in a heavy pan for a 2.5 cm / 1 in steak, turned often, off the heat at about 54 °C / 129 °F for medium-rare and rested 5 minutes. Two things decide the result more than the fire: never taking it past medium, about 60 °C / 140 °F, and slicing it thin across the grain, which changes direction inside the steak.

Also known as: デンバーステーキ · 덴버 스테이크Last reviewed Nov. 14, 20263 sources

At a glance

Cut
Chuck, under the shoulder blade (serratus ventralis)
Size
2–2.5 cm / ¾–1 in, 170–280 g / 6–10 oz
Heat
High and direct: 6–10 min on the grill, 6–8 in a pan (2.5 cm / 1 in)
Medium-rare
Off the heat at about 54 °C / 129 °F; never past medium, about 60 °C / 140 °F
Key
Slice thin across the grain, which changes direction

A shoulder steak that cooks like a loin steak

The Denver steak comes from the chuck, the shoulder, but not from its tough part. The serratus ventralis is a fan-shaped muscle that runs from the shoulder blade to the ribs, and in measurements of the chuck muscles it stood out for its high intramuscular fat. Its tenderness is moderate: more tender than most of the chuck, less than the loin. The same muscle, left on the bone, is much of the meat on chuck short ribs.

Two features shape this recipe. The marbling suits hard, direct heat and a doneness at the upper end of medium-rare. The connective tissue and the coarse grain that run through the muscle mean it does not improve past medium and has to be sliced thin. Next to its neighbor on the other side of the blade, the Denver is the more marbled and the flat iron the more tender: see Denver steak vs flat iron.

Ingredients

IngredientAmountNote
Denver steaks2 steaks, 2–2.5 cm / ¾–1 in thick (170–280 g / 6–10 oz each)serves 2; outer fat and silverskin trimmed
Coarse saltabout 1 % of the weight (3–6 g)40 minutes to a day ahead
Black pepperto tasteafter cooking
Refined oil with a high smoke point1 tbspfor the pan, or to brush the steaks for the grill
Butter, garlic and thyme30 g / 1 oz, 2 cloves, a few sprigsoptional, pan method only
Flaky salt or chimichurrito serveoptional

Method

  1. Check the steaks: a well-cut Denver has its heavy outer fat and its silverskin removed and is even in thickness. Trim any thick seam of fat or silvery membrane left on the surface; otherwise the steak cooks unevenly.
  2. At least 40 minutes ahead, or the day before, pat the steaks dry and salt them on all sides with about 1 % of their weight. Leave them uncovered on a rack in the refrigerator. Do not salt them 3–40 minutes before cooking: the surface is wet with brine then and browns poorly (see salting steak).
  3. Heat the grill or the pan as hot as it goes. On a grill, aim for about 230–290 °C / 450–550 °F at the grate, with the steaks over direct heat the whole time. A heavy cast-iron or carbon-steel pan needs 5–10 minutes over medium-high heat, until a drop of oil smokes on contact.
  4. Pat the steaks dry again. On the grill, brush them lightly with oil; in the pan, add the oil just before the steaks. Lay them down and leave them until they release, 45–60 seconds.
  5. Turn them every 30–60 seconds, or once halfway for a darker crust. A 2.5 cm / 1 in Denver takes 6–10 minutes in total on the grill and 6–8 minutes in the pan; a thinner one less (see the table below). In the pan, give the last 1–2 minutes to butter: lower the heat to medium, add the butter, garlic and thyme, and spoon the foam over the steaks.
  6. Take the steaks off at about 54 °C / 129 °F in the center for medium-rare, reading with an instant-read thermometer pushed in from the side. Rest them on a rack for 5 minutes: they rise a few degrees more.
  7. Slice thin across the grain. Look at the surface first: the lines of the grain change direction across a Denver steak, so cut it into two or three pieces where the direction changes and slice each piece across its own grain. Season with pepper and flaky salt, or serve with chimichurri.

Temperatures

The Denver is a marbled cut, and marbled cuts are usually taken to the upper end of medium-rare, where the intramuscular fat has softened; served rare, that fat can feel waxy. Past medium, about 60 °C / 140 °F, the steak turns chewy. Steaks labeled as mechanically or needle-tenderized carry surface bacteria into the center and should not be served rare. The general chart, with carryover by thickness, is the steak temperature chart.

DonenessTake off the heatAfter a 5-minute rest
Medium-rare (recommended)about 54 °C / 129 °F
129 °F
55–⁠58 °C / 136 °F
131–⁠136 °F
Medium (upper limit)56–⁠57 °C / 135 °F
133–⁠135 °F
59–⁠61 °C / 142 °F
138–⁠142 °F
USDA safe minimum (whole cuts)—63 °C / 145 °F
145 °F with a 3-minute rest

Times by thickness

Total times for medium-rare, for a steak straight from the refrigerator over a hot, direct fire or in a well-preheated heavy pan, turned often. Steaks up to about 3 cm / 1¼ in cook entirely over direct heat, and a Denver is rarely thicker. The thermometer decides; the general tables are in how long to grill steak and pan-seared steak.

ThicknessGrill, direct heat (total)Heavy pan (total)Rest
1.5 cm / ½ in3–5 min3–5 min2–3 min
2.5 cm / 1 in6–10 min6–8 min5 min

Slicing: the step that makes or breaks it

With a ribeye or a striploin, slicing is mostly a matter of presentation; with a Denver it decides whether the steak eats tender or chewy. The grain is coarse and changes direction across the muscle, so a single set of parallel cuts ends up running with the grain in part of the steak. Cut thin and across the grain, following each change of direction, the slices are tender and juicy; cut thick or with the grain, the same steak chews like a much tougher cut.

Use a long, sharp knife and a board that catches juice, and pour the resting juices back over the slices. The steak can also be served whole on the plate and sliced at the table, as long as the diner knows to cut across the grain.

Marinades and table grilling

The marbling carries enough flavor that salt and pepper are all a Denver needs, but it takes a marinade well. A soy-based marinade can stay on for 2–12 hours in the refrigerator, a citrus or vinegar one 1–8 hours; pat the steak very dry before it goes on the heat, since a wet surface steams and sugar burns (see steak marinade).

The muscle is also used in Asian table grilling, sliced thin before cooking and grilled in seconds, as in yakiniku. Kept whole, the under blade can be braised like other chuck cuts, but that gives up the reason for cutting it as a steak.

Common mistakes

Four habits account for most chewy Denver steaks. Cooking it past medium, beyond about 60 °C / 140 °F. Slicing it thick, or in one direction across the whole steak without following the grain. Leaving silverskin or a thick seam of fat on, so the steak cooks unevenly. And cooking it over moderate heat, which grays the outside before it browns: a thin, marbled steak needs the hottest grill or pan available.

Frequently asked questions

How long do you cook a Denver steak?

For medium-rare, a 2.5 cm / 1 in Denver takes 6–10 minutes in total over a hot grill and 6–8 minutes in a heavy pan, turned every 30–60 seconds; a 1.5 cm / ½ in steak, 3–5 minutes. Take it off at about 54 °C / 129 °F and rest it 5 minutes.

What temperature should a Denver steak be cooked to?

Take it off the heat at about 54 °C / 129 °F for medium-rare; after resting it finishes around 55–58 °C / 131–136 °F. Do not take it past medium, about 60 °C / 140 °F, or it turns chewy. The USDA safe minimum for whole cuts is 63 °C / 145 °F with a 3-minute rest.

Is Denver steak tough?

Not when it is cooked hot and fast to medium-rare and sliced thin across the grain. It is moderately tender: more tender than most of the chuck, less than the loin. Overcooked or sliced thick, it can feel chewy.

Can you cook Denver steak in a pan?

Yes. A heavy cast-iron or carbon-steel pan, preheated 5–10 minutes until oil smokes, cooks a 2.5 cm / 1 in Denver in 6–8 minutes, turned often, with butter, garlic and thyme in the last 1–2 minutes.

Should you marinate Denver steak?

It is not necessary, because the marbling carries flavor, but it takes a marinade well: 2–12 hours for a soy-based one, 1–8 hours for a citrus or vinegar one, always in the refrigerator. Dry it well before cooking.

Sources

3
  1. USDA Agricultural Marketing Service. Institutional Meat Purchase Specifications: Fresh Beef Series 100. Washington, DC, 2014. www.ams.usda.gov/sites/default/files/media/IMPS_100_Fresh_Beef%5B1%5D.pdf
  2. National Cattlemen's Beef Association, for the Beef Checkoff. Denver Steak (Beef. It's What's For Dinner, cut guide). www.beefitswhatsfordinner.com/cuts/cut/2985/denver-steak
  3. USDA Food Safety and Inspection Service. Safe Minimum Internal Temperature Chart. 2023. www.fsis.usda.gov/food-safety/safe-food-handling-and-preparation/food-safety-basics/safe-temperature-chart